Automatic COBRA Instalační manuál stáhnout pdf (Strana 21)

Page 21

ERASING TRANSMITTERS / FITTING PE BEAMS

ERASE TRANSMITTER FROM MEMORY

1. Select Erase mode using the LEARN button on the unit. Display

shows (E)rase (Fig 28).

2. Press and hold a button on the required transmitter for 2 seconds

until the decimal point stays on.

3. Release transmitter button until the decimal point turns off, then

press the transmitter button again for 2 seconds. The

decimal point will ﬂ ash.

4. The display will ﬂ ash twice ‘CL‘ (Clear) once the transmitter code

has been removed from memory.

ERASE TRANSMITTER FUNCTION FROM MEMORY

(Used when the transmitter to be erased is not present)

1. Select Erase mode using the LEARN button on the unit. Display

shows (E)rase (Fig 28).

2. Find the memory location of the transmitter to be erased.

Momentarily press button 1 (Fig 29) will display the next used

memory location number (eg. ‘H xx’). Momentarily pressing

button 2 (Fig 29) will display the previous memory location

number (eg. ‘H xx’).

3. Once the memory location is located, momentarily pressing button

3 (Fig 29) will clear the transmitter function that is memorised

in the displayed location number. If no transmitters are

stored in memory (memory empty) ‘H‘ will be displayed.

FITTING THE PHOTO-ELECTRIC BEAMS (OPTIONAL)

1 . Locate the Photo Electric Beam (PE) normally closed contact

type in a strategic location within doorway. We

recommend 150mm above the ﬂ oor level and as close as possible to the door opening, inside the

garage.

2. Remove link from PE and COM terminal (Fig. 30) and connect the wires from the P.E. wiring harness

as per Fig 31. Make sure to align the beams correctly. Follow the manual supplied with the Photo

Electric Beam.

WARNING - When using Auto Close Mode and PE Beams, the doorway must be clear of all ob-

structions and persons at all times. The location of the beam and manner in which it is installed

might not give safety protection at all times. Check to make sure that the height of the beam and

type used give maximum protection possible.

/($51 ,167$//

FIG 28

Location

Butto

Erase

Butto

Next Location

Button 1

FIG 29

ALM

LCK



24V

OSC

COM

FIG 30

FIG 3

24V

OSC

COM

REMOVE

LINK

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře

Automatic COBRA Instalační manuál Strana 21

Komentáře k této Příručce

Související produkty a manuály pro Otvírač garážových vrat Automatic COBRA